2006-2011 Camry Aurion · Service Manual CRUISE CONTROL SYSTEM

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.

HINT:
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


WIRING DIAGRAM

E129954E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - ECM)

  1. E135384E11
    Disconnect the A55 connector from the ECM. (LHD)

  1. Disconnect the A24 connector from the ECM. (RHD)

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LHD:
    Tester Connection
    Condition
    Specified Condition
    A55-27 (TC) - E10-13 (TC)
    Always
    Below 1 Ω
    RHD:
    Tester Connection
    Condition
    Specified Condition
    A24-27 (TC) - E10-13 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - ECM)
OK


2. CHECK HARNESS AND CONNECTOR (TERMINAL CG of DLC3 - BODY GROUND)

  1. C126742E20
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DLC3 - BODY GROUND)
OK


3. CHECK HARNESS AND CONNECTOR (TERMINAL TC of DLC3 - BODY GROUND)

  1. C126742E30
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Cruise Main Indicator Light Circuit (from Jun 2009)COMPONENTS (from Jun 2006) →