INSPECTION
Inspection · Vehicles built from Jun 2009
| INSPECT BRAKE DISC INSIDE DIAMETER |
Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc.

- Standard inside diameter:
- 190 mm (7.48 in.)
- Maximum inside diameter:
- 191 mm (7.52 in.)
| INSPECT PARKING BRAKE SHOE LINING THICKNESS |
Using a ruler, measure the thickness of the parking brake shoe lining.

- Standard thickness:
- 3.8 mm (0.150 in.)
- Minimum thickness:
- 1.0 mm (0.039 in.)
Using a ruler, measure the thickness variation within the 260° range as shown in the illustration.

- Thickness variation within 260° range:
- 0.5 mm (0.05 in.) or less.
- NOTICE:
- Always replace both the right and left parking brake shoes together.
| INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT |
Apply chalk to the inside surface of the disc, then grind down the parking brake shoe lining to fit the disc.

If the contact between the disc and the parking brake shoe lining is improper, repair it using a brake shoe grinder or replace the parking brake shoe.
