SYSTEM DESCRIPTION
Troubleshooting · Vehicles built from Jun 2009
| GENERAL |
This system uses ultrasonic sensors to detect any obstacles at the rear of the vehicle. The system then informs the driver of the distance between the sensors and the obstacles as well as their positions by sounding a buzzer.
| FUNCTION OF COMPONENTS |
| Components |
Function |
| Ultrasonic sensor (2) |
Detects the distance between the vehicle and an obstacle. |
| Clearance warning buzzer |
Sounds the buzzer to inform the driver according to the distance to an obstacle. |
| Clearance sonar main switch assembly |
Turns the Toyota parking assist-sensor system on and off. |
| Clearance warning ECU assembly |
Judges the approximate distance between the vehicle and an obstacle based on the signals from the ultrasonic sensors. Sounds the buzzer. |
| Park/neutral position switch assembly |
Transmits a shift position signal to the clearance warning ECU. |
| Speed sensor |
Detects the speed of each wheel and inputs the data into the clearance warning ECU via the combination meter. |
| OPERATION EXPLANATION |
The operating conditions of the ultrasonic sensors are as follows:
Ultrasonic Sensor
Operating Condition
Rear Center Sensor
- Ignition switch is on (IG)
- Clearance sonar main switch is on
- Shift position is R
- Ignition switch is on (IG)
| ECU AND SENSORS WHICH COMMUNICATE THROUGH LIN COMMUNICATION |
- HINT:
- The clearance warning ECU and sensors communicate with each other using LIN communication.
- Allocation refers to the process of the clearance warning ECU setting aside IDs for the sensors.
- The vehicle has 2 sensors arranged in a series, at the rear of the vehicle. The sensors are connected in a "daisy chain".
- The clearance warning ECU and sensors communicate with each other using LIN communication.
Initialization mode:
An ID is allocated to each sensor and sensor diagnosis is performed.

When any of the following conditions are met, the clearance warning ECU provides power to the first sensor in the series (rear right center sensor):
- The ignition switch is turned on (IG).
- The sensor operating conditions (described previously) are met and the clearance sonar main switch is turned on.
- Vehicle speed is below 10 km/h (6.2 mph).
- The ignition switch is turned on (IG).
After the power is supplied, the rear right center sensor enters standby mode to receive an ID from the ECU. When a certain amount of time has elapsed, the ECU sends an ID allocation signal to these sensors.
The rear right center sensor receives the ID allocation signal from the ECU and performs self-diagnosis. When the sensor self-diagnosis is complete, the ECU sends an ID allocation confirmation signal to the sensor.
After the ID allocation confirmation is performed, the ECU provides power to the second sensor in the series (rear left center sensor) via the first sensor. In the same manner as the first sensor, the second sensor enters standby mode. When a certain amount of time has elapsed, the ECU sends an ID allocation signal to the second sensor. Initialization ends when ID allocation to both ultrasonic sensors is complete.
Detection mode:
After the initialization mode is complete, the system switches into the detection mode. In the detection mode, the clearance warning ECU sends information request signals and sensor activation signals to the ultrasonic sensors and receives detection result signals from the sensors.The clearance warning ECU regularly sends ID signals, information request signals, and sensor activation signals to an ultrasonic sensor according to the LIN communication schedule.
When a certain amount of time has elapsed (sensor detection operation is complete), the clearance warning ECU sends an ID signal to the sensor to receive a detection result signal.
The ultrasonic sensor sends a detection result signal or detection information signal to the ECU.
The above operation is repeatedly performed for each ultrasonic sensor.