2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

CAN Bus Line

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

When any DTC of the CAN communication system is output, first measure the resistance between the terminals of the DLC3 to confirm the trouble area.

WIRING DIAGRAM

C152825E02

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK CAN BUS WIRE (MAIN BUS WIRE FOR DISCONNECTION, BUS WIRES FOR SHORT CIRCUIT)

  1. C126400E08
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E10-6 (CANH) - E10-14 (CANL)
    Engine switch off
    54 to 69 Ω

    Result:
    Result
    Proceed to
    OK
    A
    69 Ω or higher
    B
    Below 54 Ω
    C



B
GO TO OPEN IN CAN BUS MAIN WIRE (Click here)

C
GO TO SHORT IN CAN BUS WIRES (Click here)
A


2. CHECK CAN BUS WIRE (SHORT TO B+ IN CAN BUS WIRE)

  1. C126400E09
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E10-6 (CANH) - E10-16 (BAT)
    Engine switch off
    6 kΩ or higher
    E10-14 (CANL) - E10-16 (BAT)
    Engine switch off
    6 kΩ or higher



NG
GO TO SHORT TO B+ IN CAN BUS WIRE (Click here)
OK


3. CHECK CAN BUS WIRE (SHORT TO GND IN CAN BUS WIRE)

  1. C126400E10
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E10-4 (CG) - E10-6 (CANH)
    Engine switch off
    200 Ω or higher
    E10-4 (CG) - E10-14 (CANL)
    Engine switch off
    200 Ω or higher



NG
GO TO SHORT TO GND IN CAN BUS WIRE (Click here)
OK

GO TO "HOW TO PROCEED WITH TROUBLESHOOTING" (Click here)


← Center Airbag Sensor Communication Stop Mode (from Oct 2006)CAN Bus Line (from Jun 2009) →