2006-2011 Camry Aurion · Service Manual TRANSMISSION

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Oct 2006


DESCRIPTION
  1. Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1-trip detection logic.


CHECK MODE PROCEDURE

  1. A150238E01
    Make sure that the items below are satisfied:

    1. Battery positive voltage is 11 V or more

    2. Throttle valve is fully closed

    3. Transaxle is in the P or N position

    4. A/C is OFF

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch on (IG).

  5. Enter the following menus: Powertrain / ECT / Check Mode.

  6. A076900E02
    Change the ECM to check mode. Make sure that the MIL flashes as shown in the illustration.

    NOTICE:
    All DTCs and freeze frame data recorded will be erased if: 1) the intelligent tester is used to change the TCM from normal mode to check mode or vice-versa; or 2) during check mode, the ignition switch is turned from on (IG) to on (ACC) or off.
    Before entering check mode, make notes of any DTCs and freeze frame data that are present.

  7. Start the engine. The MIL should turn off after the engine starts.

  8. Perform "MONITOR DRIVE PATTERN" for the ECT test (Click here).
    (Or, duplicate the conditions of the malfunction described by the customer.)

  9. After duplicating the malfunction conditions, use the intelligent tester diagnosis selector to check the DTC and freeze frame data.

← DTC CHECK / CLEAR (from Jun 2009)FAIL-SAFE CHART (from Oct 2006) →