2006-2011 Camry Aurion · Service Manual TRANSMISSION

INITIALIZATION

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


RESET MEMORY

NOTICE:
  1. Perform the RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
  2. The RESET MEMORY can be performed only with the Intelligent tester.

HINT:
The ECM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.
Reset procedure is as follows.

  1. Turn the ignition switch off.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch on (IG).

  4. Turn the intelligent tester main switch on.

  5. Perform the reset memory procedure from the main menu.

  6. Enter the following menus: Powertrain / ECT / Utility.

    CAUTION:
    After performing the RESET MEMORY, be sure to perform the ROAD TEST (Click here) described earlier.

    HINT:
    The ECM is learned by performing the ROAD TEST.


    1. Tester menu flow:
      C121707E02

← INITIALIZATION (Jun 2006 – May 2009)MONITOR DRIVE PATTERN (from Jun 2006) →