HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jun 2006 – Sep 2006
- NOTICE:
- DTCs for the CAN communication system are as follows: U0101, U0073, U0100, U0129, and B1499.
- Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.
- DTCs for the CAN communication system are as follows: U0101, U0073, U0100, U0129, and B1499.
| 1.CHECK AND CLEAR DTCS |
| |||||
| 2.CHECK CAN BUS WIRE |
Check the CAN bus wires. (Click here)
| |||||
| 3.CHECK INTELLIGENT TESTER |
Select "Communication Bus Check" (Click here).
- Result:
Symptom
Proceed to
All the ECUs and sensors connected to the CAN communication system are displayed on the screen.
A (Go to step 4)
An ECU or sensor not connected to the CAN communication system is displayed on the screen.
B (Click here)
More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the "Engine" and "ECT", proceed to B.)
C (Click here)
- NOTICE:
- The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (Click here).
- Non-installed ECUs or sensors are not displayed. Do not mistake ECUs or sensors that are not installed as being in communication stop mode.
- If 2 or more ECUs or sensors are not displayed on the intelligent tester, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN branch wires.)
- The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (Click here).
|
|||||
|
|||||
| |||||
| 4.DTC COMBINATION TABLE |
Confirm trouble according to the combination of output DTCs regarding the CAN communication system (Click here).
- HINT:
- Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester "Communication Bus Check" screen.
| |||||
| 5.CIRCUIT INSPECTION |
| |||||
| 6.IDENTIFICATION OF PROBLEM |
| |||||
| 7.REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
| |||||