2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

RESULT LIST OF HOW TO PROCEED WITH TROUBLESHOOTING: 
Symptom
Suspected Area
See page
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in CAN Main Bus Wire"
Open in CAN Main Bus Wire
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short in CAN Bus Wires"
Short in CAN Bus Wires
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to B+ in CAN Bus Wire"
Short to B+ in CAN Bus Wire
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to GND in CAN Bus Wire"
Short to GND in CAN Bus Wire
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in One Side of CAN Sub Bus Wire"
Open in One Side of CAN Branch Wire
Click here
COMMUNICATION STOP MODE TABLE: 
Symptom
Suspected Area
See page
"ABS/VSC/TRAC" is not displayed on the intelligent tester (with VSC)
Skid Control ECU Communication Stop Mode
Click here
"A/C" is not displayed on the intelligent tester
Air Conditioning Amplifier Communication Stop Mode
Click here
"Body/Gateway" is not displayed on the intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Steering Angle Sensor" is not displayed on the intelligent tester
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate/Deceleration Sensor" is not displayed on the intelligent tester
Yaw Rate Sensor Communication Stop Mode
Click here
"Engine" is not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
"Meter" is not displayed on the intelligent tester
Combination Meter Communication Stop Mode
Click here
"SRS Airbag" is not displayed on the intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here
← HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009)PROBLEM SYMPTOMS TABLE (from Jun 2009) →