2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Skid Control ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Skid Control ECU Communication Stop Mode
  1. "ABS/VSC/TRAC" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Skid Control ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the skid control ECU
  2. Skid control ECU branch wire or connector
  3. Skid control ECU

HINT:
"ABS/VSC/TRAC" refers to the circuit that includes the skid control ECU.


WIRING DIAGRAM

C126207E24

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wire.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (SKID CONTROL ECU BRANCH WIRE)
  1. Turn the engine switch off.

  1. C152827E03
    Disconnect skid control ECU connector A26.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    A26-35 (CANH) - A26-14 (CANL)
    Engine switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN NO. 1 BUS BRANCH WIRE OR CONNECTOR (SKID CONTROL ECU BRANCH WIRE)
OK


2. CHECK WIRE HARNESS (POWER SOURCE CIRCUIT)

  1. C152827E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    A26-4 (GND1) - Body ground
    Always
    Below 1 Ω
    A26-1 (GND2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    A26-28 (IG1) - Body ground
    Engine switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR


← U1002 Lost Communication with Gateway Module (from Jun 2009)Air Conditioning Amplifier Communication Stop Mode (from Oct 2006) →