Yaw Rate Sensor Communication Stop Mode
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Yaw Rate Sensor Communication Stop Mode |
|
|
- HINT:
- "Yaw Rate/Decelerate Sensor" refers to the circuit that includes the yaw rate sensor.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- HINT:
- Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE) |
Turn the engine switch off.
Disconnect the yaw rate sensor connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Value
E34-2 (CANH) - E34-3 (CANL)
Engine switch off
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (POWER SOURCE CIRCUIT) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Value
E34-4 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Value
E34-1 (IG) - Body ground
Engine switch on (IG)
10 to 14 V
|
|
||||
| OK | ||
| ||
