ECM Communication Stop Mode
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| ECM Communication Stop Mode |
|
|
WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
- HINT:
- Operating the ignition switch, any other switches or any triggers related ECU and sensor communication on the CAN, which would cause resistance reading variations.
| 1. CHECK OPEN IN CAN BUS WIRE (ECU MAIN BUS WIRE) |
Reconnect the CAN main bus wire connector (A40) to the No. 4 CAN J/C (front side of the vehicle).

Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
- 2AZ-FE:
Tester Connection
Condition
Specified Value
A24-41 (CANH) - A24-49 (CANL)
Ignition switch off
108 to 132 Ω
- 2GR-FE:
Tester Connection
Condition
Specified Value
A55-41 (CANH) - A55-49 (CANL)
Ignition switch off
108 to 132 Ω
|
|
||||
| OK | |
| 2. CHECK ECM POWER SOURCE CIRCUIT |
Check the ECM power source circuit (2AZ-FE: Click hereor 2GR-FE: Click here)
|
|
||||
| OK | ||
| ||
