2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Gateway ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

Detection Item
Symptom
Trouble Area
Gateway ECU Communication Stop Mode
  1. "Gateway" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  1. Applies to "Gateway ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the gateway ECU
  1. Gateway ECU branch wire or connector
  1. Gateway ECU

HINT:
"Gateway" refers to the circuit that includes the gateway ECU.


WIRING DIAGRAM

C142222E08

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the engine switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (GATEWAY ECU BRANCH WIRE)
  1. Turn the engine switch off.

  1. C142190E06
    Disconnect gateway ECU connector E70.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E70-16 (CA1H) - E70-15 (CA1L)
    Engine switch on (IG)
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN NO. 1 BUS BRANCH WIRE OR CONNECTOR (GATEWAY ECU BRANCH WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

  1. C142190E07
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E70-4 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    E70-2 (BATT) - Body ground
    Always
    10 to 14 V
    E70-10 (IG1) - Body ground
    Engine switch on (IG)
    10 to 14 V
    E70-9 (IG2) - Body ground
    Engine switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE GATEWAY ECU


← Air Conditioning Amplifier Communication Stop Mode (from Oct 2006)Gateway ECU Communication Stop Mode (from Jun 2009) →