2006-2011 Camry Aurion · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to the ON position, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned to the ON position, the MIL should be illuminated and should then turn off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the intelligent tester.

WIRING DIAGRAM

A142859E03

INSPECTION PROCEDURE


1. CHECK THAT MIL IS ILLUMINATED
  1. Perform troubleshooting in accordance with the table below.

    Result:
    Condition
    Proceed to
    MIL remains ON
    A
    MIL does not illuminate
    B



B
Go to step 5
A


2. CHECK WHETHER MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Check if any DTCs have been stored. Note down any DTCs.

  1. Clear the DTCs (Click here).

  1. Check if the MIL goes off.

    Standard:
    MIL goes off.



OK
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
NG


3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)

  1. A115671E54
    Disconnect the A24 ECM connector.

  1. Turn the ignition switch to the ON position.

  1. Check that the MIL is not illuminated.

    OK:
    MIL is not illuminated.

  1. Reconnect the ECM connector.



OK
REPLACE ECM
NG


4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM)

  1. A142862E02
    Disconnect the F1 combination meter connector.

  1. Disconnect the A24 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    W (A24-24) or CHK (F1-9) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the ECM connector.



OK
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5. CHECK THAT MIL IS ILLUMINATED
  1. Check if the MIL is illuminated when the ignition switch is turned to the ON position.

    OK:
    MIL is illuminated.



OK
SYSTEM OK
NG


6. CHECK THAT ENGINE STARTS
  1. Turn the ignition switch to the ON position.

  1. Start the engine.

    Result:
    Result
    Proceed to
    Engine starts
    A
    Engine does not start*
    B

    HINT:
    *: The intelligent tester cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT
A


7. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
  1. Check the MIL circuit (Click here).



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

CHECK AND REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)


← MIL Circuit (Jun 2006 – Sep 2006)MIL Circuit (from Jun 2009) →