Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
A bolt without a torque specification is shown in the standard bolt chart (Click here).
1.
REMOVE LUGGAGE COMPARTMENT DOOR COVER
Using a clip remover, remove the 13 clips and luggage compartment door cover.
2.
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
3.
REMOVE SPARE WHEEL COVER CLAMP
4.
REMOVE SPARE WHEEL COVER ASSEMBLY
5.
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Remove the 2 screws and the 2 No. 1 luggage compartment trim hooks.
6.
REMOVE REAR FLOOR FINISH PLATE
Disengage the 7 clips and remove the rear floor finish plate.
7.
ADJUST LUGGAGE COMPARTMENT DOOR
Horizontally and vertically adjust the door by loosening the door side hinge bolts.
Torque:
7.5 N*m{
77 kgf*cm
, 66 in.*lbf
}
Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic hammer.
Tighten the striker mounting screws after the adjustment.
Torque:
5.5 N*m{
56 kgf*cm
, 49 in.*lbf
}
8.
INSTALL REAR FLOOR FINISH PLATE
Engage the 7 clips and install the rear floor finish plate.
9.
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Install the 2 No. 1 luggage compartment trim hooks with the 2 screws.
10.
INSTALL SPARE WHEEL COVER ASSEMBLY
11.
INSTALL SPARE WHEEL COVER CLAMP
12.
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
13.
INSTALL LUGGAGE COMPARTMENT DOOR COVER
Install the luggage compartment door cover with the 13 clips.