2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


CHECK CERTIFICATION ECU
E125964E03
  1. Disconnect the E58 ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    +B (E58-1) - Body ground
    W - Body ground
    +B power supply
    Always
    10 to 14 V
    IG (E58-18) - Body ground
    LG - Body ground
    Ignition power supply
    Engine switch off
    Below 1 V
    IG (E58-18) - Body ground
    LG - Body ground
    Ignition power supply
    Engine switch on (IG)
    10 to 14 V
    E (E58-17) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    ACC (E58-19) - Body ground
    L - Body ground
    ACC power supply
    Engine switch off
    Below 1 V
    ACC (E58-19) - Body ground
    L - Body ground
    ACC power supply
    Engine switch on (ACC)
    10 to 14 V
    TSW1 (E58-3) - Body ground
    GR*1 - Body ground
    Entry lock switch signal
    Front lock switch LH not pushed*1
    10 kΩ or higher
    LG*2 - Body ground
    Front lock switch RH not pushed*2
    TSW1 (E58-3) - Body ground
    GR*1 - Body ground
    Entry lock switch signal
    Front lock switch LH pushed*1
    Below 1 Ω
    LG*2 - Body ground
    Front lock switch RH pushed*2
    TSW2 (E58-4) - Body ground
    L*1 - Body ground
    Entry lock switch signal
    Front lock switch RH not pushed*1
    10 kΩ or higher
    GR*2 - Body ground
    Front lock switch LH not pushed*2
    TSW2 (E58-4) - Body ground
    L*1 - Body ground
    Entry lock switch signal
    Front lock switch RH pushed*1
    Below 1 Ω
    GR*2 - Body ground
    Front lock switch LH pushed*2
    LIN (E58-10) - Body ground
    BE - Body ground
    LIN line
    Always
    10 kΩ or higher
    CANH (E58-27) - Body ground
    L - Body ground
    CAN line
    Always
    10 kΩ or higher
    CANL (E58-28) - Body ground
    W - Body ground
    CAN line
    Always
    10 kΩ or higher
    AGND (E58-40) - Body ground
    G - Body ground
    Ground
    Always
    Below 1 Ω
    TSW5 (E58-7) - Body ground
    G - Body ground
    Luggage compartment door opener outer switch signal
    Opener switch OFF
    10 kΩ or higher
    TSW5 (E58-7) - Body ground
    G - Body ground
    Luggage compartment door opener outer switch signal
    Opener switch ON
    Below 1 Ω

    HINT:
    *1: for LHD
    *2: for RHD

    If the result is not as specified, the wire harness side may have a malfunction.

  3. Reconnect the E58 ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CLG1 (E58-33) - E (E58-17)
    LG*1 - W-B
    Door electrical key oscillator (driver door) sensor signal
    All doors closed, all doors locked and engine switch off
    Alternating between 5 V and below 1 V
    GR*2 - W-B
    CLG1 (E58-33) - E (E58-17)
    LG*1 - W-B
    Door electrical key oscillator (driver door) sensor signal
    Door unlocked or door open
    Below 1 V
    GR*2 - W-B
    SEN1 (E58-22) - E (E58-17)
    B*1 - W-B
    Touch (driver door) sensor detection signal
    Outside door handle touched
    Below 1 V
    BE*2 - W-B
    SEN1 (E58-22) - E (E58-17)
    B*1 - W-B
    Touch (driver door) sensor detection signal
    Outside door handle not touched (Have the electrical key outside the cabin)
    10 to 14 V
    BE*2 - W-B
    SEL1 (E58-5) - E (E58-17)
    V*1 - W-B
    Touch (driver door) sensor activation control signal
    Move the key more than 5 m (16.4 ft) away from the driver door
    10 to 14 V
    P*2 - W-B
    SEL1 (E58-5) - E (E58-17)
    V*1 - W-B
    Touch (driver door) sensor activation control signal
    Move the key to the outside handle
    Below 1 V
    P*2 - W-B
    CLG2 (E58-35) - E (E58-17)
    GR*1 - W-B
    Door electrical key oscillator (passenger door) sensor signal
    All doors closed, all doors locked and engine switch off
    Alternating between 5 V and below 1 V
    LG*2 - W-B
    CLG2 (E58-35) - E (E58-17)
    GR*1 - W-B
    Door electrical key oscillator (passenger door) sensor signal
    Door unlocked or door open
    Below 1 V
    LG*2 - W-B
    SEN2 (E58-23) - E (E58-17)
    BE*1 - W-B
    Touch (passenger door) sensor detection signal
    Outside door handle touched
    Below 1 V
    B*2 - W-B
    SEN2 (E58-23) - E (E58-17)
    BE*1 - W-B
    Touch (passenger door) sensor detection signal
    Outside door handle not touched (Have the electrical key outside the cabin)
    10 to 14 V
    B*2 - W-B
    SEL2 (E58-6) - E (E58-17)
    P*1 - W-B
    Touch (passenger door) sensor activation control signal
    Move the key more than 5 m (16.4 ft) away from the passenger door
    10 to 14 V
    V*2 - W-B
    SEL2 (E58-6) - E (E58-17)
    P*1 - W-B
    Touch (passenger door) sensor activation control signal
    Move the key to the outside handle
    Below 1 V
    V*2 - W-B
    CLG5 (E58-11) - CG5B (E58-12)
    R - W
    Indoor electrical key oscillator (front) sensor signal
    Within 30 seconds driver side door opened and closed, engine switch off
    Alternating between 5 V and below -5 V
    CLG5 (E58-11) - CG5B (E58-12)
    R - W
    Indoor electrical key oscillator (front) sensor signal
    Engine switch on (IG)
    Below 1 V
    CLG6 (E58-13) - CG6B (E58-14)
    Y - B
    Indoor electrical key oscillator (rear) sensor signal
    Within 30 seconds after driver side door opened and closed, engine switch off
    Alternating between 5 V and below -5 V
    CLG6 (E58-13) - CG6B (E58-14)
    Y - B
    Indoor electrical key oscillator (rear) sensor signal
    Engine switch on (IG)
    Below 1 V
    CLG7 (E58-15) - CG7B (E58-16)
    R - W
    Luggage electrical key oscillator (inner) sensor signal
    Luggage compartment door opening switch ON
    Alternating between 5 V and below -5 V
    CLG7 (E58-15) - CG7B (E58-16)
    R - W
    Luggage electrical key oscillator (inner) sensor signal
    Luggage compartment door opening switch OFF
    Below 1 V
    CLG8 (E58-31) - CG8B (E58-32)
    V - P
    Luggage electrical key oscillator (outer) sensor signal
    Luggage compartment door opening switch ON
    Alternating between 5 V and below -5 V
    CLG8 (E58-31) - CG8B (E58-32)
    V - P
    Luggage electrical key oscillator (outer) sensor signal
    Luggage compartment door opening switch OFF
    Below 1 V
    RC0 (E58-29) - E (E58-17)
    G - W-B
    Entry door control receiver power source
    Engine switch off, all doors closed and electrical key switch on
    4.5 to 5.5 V
    RC0 (E58-29) - E (E58-17)
    G - W-B
    Entry door control receiver power source
    Engine switch off, all doors closed and electrical key switch off
    Below 1 V
    RSSI (E58-39) - E (E58-17)
    R - W-B
    Entry door control receiver electric wave existence signal
    Engine switch off, all doors closed, the electrical key is not in the detection area
    10 to 14 V
    RSSI (E58-39) - E (E58-17)
    R - W-B
    Entry door control receiver electric wave existence signal
    Engine switch off, all doors closed, the electrical key is in the detection area
    Below 1 V
    RDA (E58-38) - E (E58-17)
    Y - W-B
    Entry door control receiver data input signal
    Engine switch off, all doors closed and electrical key switch off
    10 to 14 V
    (Pulse generation)
    RDA (E58-38) - E (E58-17)
    Y - W-B
    Entry door control receiver data input signal
    Engine switch off, all doors closed and electrical key switch on
    Pulse generation
    RDA (E58-38) - Body ground
    Y - Body ground
    Tuner input signal
    Engine switch off, all doors closed, the electrical key is not in the detection area
    10 to 14 V
    (Pulse generation)
    RDA (E58-38) - Body ground
    Y - Body ground
    Tuner input signal
    The electrical key is in the detection area.
    Pulse generation
    ASEL (E58-37) - Body ground*3
    V - Body ground
    Cabin / luggage receiver select signal
    Engine switch off, luggage compartment door closed and the electrical key is in the luggage detection area
    4.6 to 6.0 V
    ASEL (E58-37) - Body ground*3
    V - Body ground
    Cabin / luggage receiver select signal
    Engine switch off, luggage compartment door open
    Below 1 V
    VC5 (E58-30) - Body ground
    R - Body ground
    Transponder key amplifier power supply
    Electrical key is not in the cabin.
    Below 1 V
    VC5 (E58-30) - Body ground
    R - Body ground
    Transponder key amplifier power supply
    Have the electrical key outside the cabin and open the driver's door.
    4.5 to 5.5 V
    TXCT (E58-8) - Body ground
    GR - Body ground
    Transponder key amplifier output signal
    Electrical key is not in the cabin.
    Below 1 V
    TXCT (E58-8) - Body ground
    GR - Body ground
    Transponder key amplifier output signal
    Have the electrical key outside the cabin and open the driver's door.
    Pulse generation
    (See waveform 1)
    CODE (E58-9) - Body ground
    W - Body ground
    Transponder key amplifier communication signal
    Electrical key is not in the cabin.
    Below 1 V
    CODE (E58-9) - Body ground
    W - Body ground
    Transponder key amplifier communication signal
    Have the electrical key outside the cabin and open the driver's door. Hold the electrical key close to the engine switch with the brake pedal depressed.
    Pulse generation
    (See waveform 2)
    BZR (E58-21) - Body ground
    BE - Body ground
    Wireless door lock buzzer signal
    Wireless door lock buzzer OFF
    Below 1 V
    BZR (E58-21) - Body ground
    BE - Body ground
    Wireless door lock buzzer signal
    Wireless door lock buzzer ON
    Pulse generation

    HINT:
    *1: for LHD
    *2: for RHD
    *3: w/ Electrical Key Antenna

    If the result is not as specified, the ECU may have a malfunction.

  5. B112486E01
    Inspect using an oscilloscope.
    Waveform 1 (Reference): 
    Terminal
    TXCT - Body ground
    Tool Setting
    2 V/DIV., 10 ms./DIV.
    Condition
    Have the electrical key outside the cabin and open the driver's door.

  6. B112487E01
    Inspect using an oscilloscope.
    Waveform 2 (Reference): 
    Terminal
    CODE - Body ground
    Tool Setting
    2 V/DIV., 20 ms./DIV.
    Condition
    Have the electrical key outside the cabin and open the driver's door. Hold the electrical key close to the engine switch with the brake pedal depressed.


MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

  1. Measure the voltage and resistance according to the value(s) in the table below.
    B150879E01

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CANN (E8-15) - Body ground
    W - Body ground
    CAN Line
    Always
    10 kΩ or higher
    CANP (E8-16) - Body ground
    L - Body ground
    CAN Line
    Always
    10 kΩ or higher
    STP (IL-7) - Body ground
    L - Body ground
    Stop light switch signal
    Brake pedal depressed
    10 to 14 V
    STP (IL-7) - Body ground
    L - Body ground
    Stop light switch signal
    Brake pedal released
    Below 1 V
    If the result is not as specified, the junction block may have a malfunction.

← TERMINALS OF ECU (Oct 2006 – May 2009)DIAGNOSIS SYSTEM (from Oct 2006) →