2006-2011 Camry Aurion · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT COOLING FAN SYSTEM
  1. Put the vehicle in the following conditions:

    1. Turn the ignition switch off.

    2. The coolant temperature is less than 95°C (203°F).

    3. The battery voltage is between 9 and 14 V.

    4. The A/C switch is OFF.

  1. Connect the 400 A probe of the ammeter to terminals M+ (M) and M+ (S) of the cooling fan motor.

  1. Turn the ignition switch on (IG) and wait for approximately 10 seconds. Check that the fan stops.

  1. Start the engine. Check that the fan stops with the engine idling.

    HINT:
    1. Make sure that the radiator engine coolant temperature is less than 95°C (203°F).
    1. Turn the A/C switch OFF.

  1. Check that the fan operates when the A/C switch is turned on (MAX COOL and the magnetic clutch is operating).

    Standard current:
    Item
    Specified Condition
    Cooling fan motor
    2 to 10 A
    Cooling fan motor No. 2
    2 to 10 A

    HINT:
    The coolant temperature is less than 95°C (203°F).

  1. Check that the fan operates when the engine coolant temperature sensor connector is disconnected.

    Standard current:
    Item
    Specified Condition
    Cooling fan motor
    2 to 15 A
    Cooling fan motor No. 2
    2 to 15 A

  1. A139339E05
    After the engine is warmed up, check that the fan operates as shown in the illustration.

    HINT:
    1. The coolant temperature at which the fan starts operating is approximately 95°C (203°F).
    1. This system can also be checked using the intelligent tester.
    1. Select the following menu items: Powertrain / Engine / Data List / Initial Engine Coolant Temp.

← SYSTEM DIAGRAM (from Oct 2006)ON-VEHICLE INSPECTION (Oct 2006 – May 2009) →