ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT COOLING FAN RELAY NO. 1 |
Remove the relay from the engine room relay block.

Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 Ω or higher
3 - 5
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
- If the result is not as specified, replace the relay.
Install the relay to the engine room relay block No. 2.
| INSPECT COOLING FAN RELAY NO. 2 |
Remove the relay from the engine room relay block.

Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 4
Below 1 Ω
3 - 5
10 Ω or higher
3 - 4
10 Ω or higher
(when battery voltage is applied to terminals 1 and 2)
3 - 5
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
- If the result is not as specified, replace the relay.
Install the relay.
| INSPECT COOLING FAN RELAY NO. 3 |
Remove the relay from the engine room relay block.

Measure the resistance of the relay.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 Ω or higher
3 - 5
Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)
- If the result is not as specified, replace the relay.
Install the relay.
