REMOVAL
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
SEPARATE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle) |
 |
- HINT:
-
Click here.
| 2.
SEPARATE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle) |
 |
- HINT:
-
Click here.
| 3.
REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle) |
 |
- Using SST, hold the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Remove the 8 bolts, rear spacer, drive plate and front spacer.
| 4.
REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)
|
 |
- Put matchmarks on the clutch cover assembly and flywheel sub-assembly.
Loosen the 6 bolts one turn at a time until spring tension is released.
Remove the 6 bolts and pull off the clutch cover assembly.
- NOTICE:
- Do not drop the clutch disc assembly.
| 5.
REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)
|
 |
- NOTICE:
- Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.
| 6.
REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle) |
 |
- Using SST, hold the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Remove the 8 bolts and flywheel.
| 7.
REMOVE ENGINE REAR OIL SEAL |
 |
- Using a knife, cut through the oil seal lip.
Using a screwdriver with its tip taped, pry out the oil seal.
- NOTICE:
- After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.