REASSEMBLY
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – May 2009 from Jun 2009
| 1.
INSTALL PLANETARY GEAR |
 |
- Apply high-temperature grease to the planetary gears and pin parts of the planetary shaft.
Install the 3 planetary gears.
| 2.
INSTALL RUBBER SEAL |
 |
- Install the rubber seal to the repair service starter kit.
| 3.
INSTALL STARTER ARMATURE ASSEMBLY |
 |
- Apply high-temperature grease to the washer and the armature shaft.
- Install the starter armature to the starter commutator end frame.
Install the washer.
Using snap ring pliers, securely install a new snap ring to the armature shaft groove.
- NOTICE:
- Be sure to install the snap ring in the armature shaft groove securely.
- Be sure to properly install the snap ring because it expands easily.
- Using a vernier caliper, measure the length of the snap ring.
- Maximum length:
- 5.0 mm (0.197 in.)
If the length is more than the maximum, replace the snap ring with a new one.
| 4.
INSTALL STARTER COMMUTATOR END FRAME COVER |
 |
- Install the starter commutator end frame cover to the starter commutator end frame.
| 5.
INSTALL STARTER ARMATURE PLATE |
 |
- Insert the armature plate into the starter yoke.
Align the keyway of the starter armature plate with the key inside the starter yoke, and install the starter armature plate.
| 6.
INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY |
 |
- Align the rubber of the end frame with the cutout of the starter yoke.
Install the starter commutator end frame to the starter yoke.
- NOTICE:
- The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet to break.
| 7.
INSTALL STARTER YOKE ASSEMBLY |
 |
- Align the protrusion of the starter yoke with the cutout of the repair service starter kit.
- Install the starter yoke with the 2 through bolts.
-
Torque:
- 6.0 N*m{
61 kgf*cm
, 53 in.*lbf
}
| 8.
INSTALL MAGNET STARTER SWITCH ASSEMBLY |
 |
- Apply high-temperature grease to the plunger and the lever.
- Pull the pinion gear and push down the lever.
- Temporarily install the magnet starter switch by hooking the plunger into the upper side of the pinion drive lever.
- Install the magnet starter switch with the 2 nuts.
-
Torque:
- 7.5 N*m{
76 kgf*cm
, 66 in.*lbf
}
- Connect the lead wire to the magnet starter switch with the nut.
-
Torque:
- 10 N*m{
102 kgf*cm
, 7 ft.*lbf
}