2006-2011 Camry Aurion · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL TRANSMISSION WIRE

  1. D030867
    Coat a new O-ring of the transmission wire connector with ATF and install it to the transmission wire.

  1. D030866
    Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission wire connector.


2. CONNECT TRANSMISSION WIRE

  1. C135717
    Coat the O-ring of the ATF temperature sensor with ATF.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf }

  1. Connect the 7 shift solenoid valve connectors.


3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

  1. D030865E01
    Install the 2 magnets in the oil pan.

  1. Apply adhesive or equivalent to new 18 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. C091925
    Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.

    Torque:
    7.8 N*m{ 79 kgf*cm , 69 in.*lbf }

    NOTICE:
    Since the bolts should be seal bolts, apply adhesive to the bolts and tighten them within 10 minutes of application.


4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
Click here.

← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →