2.
REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
Remove the 18 bolts, oil pan and gasket.
NOTICE:
Some fluid will remain in the oil pan. remove all the pan bolts, and carefully remove the oil pan assembly.
Remove the 2 magnets from the oil pan.
Examine particles in the pan.
Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle. Steel (magnetic): bearing, gear and plate wear Brass (non-magnetic): bearing wear
Result:
Steel (magnetic):
bearing, gear and plate wear
Brass (non-magnetic):
bearing wear
3.
DISCONNECT TRANSMISSION WIRE
Disconnect the 7 shift solenoid valve connectors.
Remove the bolt and lock plate, and disconnect the ATF temperature sensor.