Removal / installation · Vehicles built from Oct 2006
1.
ADJUST SHIFT LEVER POSITION
Move the shift lever to the N position.
Remove the nut and transmission control cable assembly from the control shaft lever.
Align the protrusions of the park/neutral position switch.
Move the slider in the direction indicated by arrow A and pull up the lock piece in the direction indicated by arrow B.
NOTICE:
Do not damage the boot.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Torque:
13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
Push in the lock piece.
NOTICE:
Firmly push in the lock piece until the slider lock is engaged.
Start the engine and make sure that the vehicle moves forward when moving the lever from the N to the D position and moves rearward when moving it to the R position. If it becomes hard to move the shift lever, readjust the shift lever position.