DISASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1. INSPECT OIL PUMP ASSEMBLY |
Turn the drive gear with 2 screwdrivers and make sure that it rotates smoothly.

- NOTICE:
- Be careful not to damage the oil seal lip.
| 2. REMOVE CLUTCH DRUM OIL SEAL RING |
Remove the 2 clutch drum oil seal rings.

| 3. REMOVE STATOR SHAFT ASSEMBLY |
Using a torx socket (T30), remove the 11 bolts and stator shaft.

Keep the gears in assembling order.
| 4. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
Push the driven gear to one side of the body.

Using a feeler gauge, measure the clearance.
- Standard body clearance:
- 0.10 to 0.17 mm (0.0039 to 0.0067 in.)
- Maximum body clearance:
- 0.17 mm (0.0067 in.)
Using a feeler gauge, measure the tip clearance between the driven gear teeth and drive gear teeth.

- Standard tip clearance:
- 0.07 to 0.15 mm (0.0028 to 0.0059 in.)
- Maximum tip clearance:
- 0.15 mm (0.0059 in.)
Using a straight edge and feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.02 to 0.05 mm (0.0008 to 0.0020 in.)
- Maximum side clearance:
- 0.05 mm (0.0020 in.)
Drive gear thickness: mm (in.) Mark
Thickness
A
11.690 to 11.699 (0.4602 to 0.4606)
B
11.700 to 11.709 (0.4606 to 0.4610)
C
11.710 to 11.720 (0.4610 to 0.4614)
D
11.721 to 11.730 (0.4615 to 0.4618)
E
11.731 to 11.740 (0.4619 to 0.4622)
Driven gear thickness: mm (in.) Mark
Thickness
A
11.690 to 11.699 (0.4602 to 0.4606)
B
11.700 to 11.709 (0.4606 to 0.4610)
C
11.710 to 11.720 (0.4610 to 0.4614)
D
11.721 to 11.730 (0.4615 to 0.4618)
E
11.731 to 11.740 (0.4619 to 0.4622)
| 5. REMOVE FRONT OIL PUMP DRIVE GEAR |
Remove the front oil pump drive gear.

| 6. REMOVE FRONT OIL PUMP DRIVEN GEAR |
Remove the front oil pump driven gear.

| 7. REMOVE FRONT OIL PUMP BODY O-RING |
Using a screwdriver, remove the O-ring.

- HINT:
- Tape the screwdriver tip before use.
| 8. REMOVE FRONT OIL PUMP OIL SEAL |
Mount the oil pump in a soft jaw vise.

Using SST, remove the oil seal from the oil pump body.
- SST
- 09308-00010
