REASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
INSTALL FRONT OIL PUMP OIL SEAL |
 |
- Using SST and a hammer, install a new oil seal to the oil pump body.
- SST
- 09350-32014
(09351-32140)
- HINT:
- The seal end should be flush with the outer edge of the oil pump.
Coat the lip of the oil seal with MP grease.
| 2.
INSTALL FRONT OIL PUMP BODY O-RING |
 |
- Coat a new O-ring with ATF, and install it to the oil pump body.
- NOTICE:
- Make sure that the O-ring is not twisted or pinching.
- Apply enough ATF to the O-ring prior to installation.
| 3.
INSTALL FRONT OIL PUMP DRIVEN GEAR |
 |
- Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side up.
| 4.
INSTALL FRONT OIL PUMP DRIVE GEAR |
 |
- Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side up.
| 5.
INSTALL STATOR SHAFT ASSEMBLY |
 |
- Align the bolt holes in the stator shaft assembly with those in the front oil pump and gear body sub-assembly.
Using a torx socket (T30), install the 11 bolts.
-
Torque:
- 9.8 N*m{
100 kgf*cm
, 87 in.*lbf
}
| 6.
INSTALL CLUTCH DRUM OIL SEAL RING |
 |
- Coat 2 new clutch drum oil seal rings with ATF.
Install the 2 clutch drum oil seal rings.
- NOTICE:
- Do not expand the ring ends excessively.