2006-2011 Camry Aurion · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL UNDERDRIVE PLANETARY RING GEAR

  1. D008112E01
    Install a new snap ring to the outer race of the tapered roller bearing.

    HINT:
    If replacing the bearing, also replace the counter driven gear with a new one.

  1. D008113
    Using a piston ring compressor, squeeze the snap ring.

  1. C134902E01
    Using SST and a press, press in the outer race of the angular ball bearing.
    SST
    09950-60020   (09951-00890)
    09950-70010   (09951-07100)

    NOTICE:
    Do not damage the snap ring during installation of the outer race.

  1. C137499E01
    Install the underdrive planetary ring gear to the counter driven gear.

  1. C134900E01
    Using snap ring pliers, install the snap ring.


2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY

  1. C134903E01
    Using a press, press the angular ball bearing inner race (rear side) into the underdrive planetary gear.
    SST
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)
    09726-40010  

  1. C134904
    Install the counter driven gear with planetary ring gear to the underdrive planetary gear.

  1. C134905E01
    Using SST and a press, press in the angular ball bearing inner race (front side).
    SST
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)
    09726-40010  

    NOTICE:
    Press the counter driven gear while rotating it.

  1. C134906E01
    Using a press, press in the parking lock gear.
    SST
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)
    09316-20011  

    NOTICE:
    Press the counter driven gear while rotating it.


3. INSTALL DIFFERENTIAL DRIVE PINION

  1. D026434E01
    Using a press, press in the differential drive pinion.
    SST
    09726-40010  
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)

    NOTICE:
    Press the counter driven gear while rotating it.


4. INSTALL CYLINDRICAL ROLLER BEARING RACE INNER

  1. C134907E01
    Using a press, press in the cylindrical roller bearing race inner.
    SST
    09515-21010  
    09950-60010   (09951-00260)
    09950-70010   (09951-07100)

    NOTICE:
    Press the counter driven gear while rotating it.


5. INSTALL FRONT PLANETARY GEAR NUT

  1. C134897E01
    Clamp the underdrive planetary gear in a soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. Using a socket wrench, install a new lock nut.

    Torque:
    280 N*m{ 2,855 kgf*cm , 207 ft.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 750 mm (29.53 in.).

  1. C056809
    Using a chisel and hammer, stake the lock nut.

    CAUTION:
    Be sure that there are no cracks on the nut.

← INSPECTION (from Jun 2006)COMPONENTS (from Jun 2006) →