DISASSEMBLY
Removal / installation · Vehicles built from Jun 2006
| 1.
REMOVE CONTROL SHIFT LEVER BUSHING |
 |
- Remove the control shift lever bushing from the No. 2 selecting bellcrank.
| 2.
REMOVE NO. 1 SELECTING BELLCRANK DUST COVER |
 |
- Remove the No. 1 selecting bellcrank dust cover from the No. 2 selecting bellcrank.
| 3.
REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY |
 |
- Remove the nut, wave washer, and selecting bellcrank No. 2 plate washer from the No. 2 selecting bellcrank.
- Remove the selecting bellcrank support sub-assembly from the No. 2 selecting bellcrank.
| 4.
REMOVE NO. 2 SELECTING BELLCRANK DUST COVER |
 |
- Remove the No. 2 selecting bellcrank dust cover from the No. 2 selecting bellcrank.
| 5.
REMOVE SELECTING BELLCRANK NO. 2 BUSHING |
 |
- Remove the selecting bellcrank bushing from the No. 2 selecting bellcrank.
| 6.
REMOVE NO. 2 SHIFT LEVER INNER |
 |
- Hold the shift and select lever in a vise using aluminum plates.
- NOTICE:
- Do not damage the shift and select lever shaft.
Using a pin punch (φ 5 mm), remove the 2 shift inner lever slotted pins.
- NOTICE:
- Do not damage the shift and select lever shaft.
Apply force to the No. 1 select return compression spring and No. 2 select return compression spring, then hold them in a vise using aluminum plates.
- Using 2 screwdrivers and a hammer, remove the select spring No. 2 seat snap ring from the shift and select lever shaft.
- NOTICE:
- Do not damage the shift and select lever shaft.
- Remove the No. 2 select spring seat, No. 2 select return compression spring, and No. 2 shift lever inner from the shift and select lever shaft.
| 7.
REMOVE NO. 1 SELECT SPRING SEAT |
 |
- Remove the shift inter lock plate, No. 1 select return compression spring and No. 1 select spring seat from the shift and select lever shaft.
| 8.
REMOVE SHIFT INTERLOCK PLATE COVER |
 |
- Remove the shift interlock plate cover from the shift interlock plate.
| 9.
REMOVE NO. 1 SHIFT LEVER INNER |
 |
- Remove the No. 1 shift lever inner from the shift interlock plate.
| 10.
REMOVE SELECT SPRING NO. 1 SEAT SHAFT SNAP RING |
 |
- Using 2 screwdrivers and a hammer, remove the select spring No. 1 seat shaft snap ring.
- NOTICE:
- Do not damage the shaft.
| 11.
REMOVE CONTROL SHAFT COVER OIL SEAL |
 |
- Using a screwdriver, remove the control shaft cover oil seal from the control shaft cover.
- HINT:
- Tape the screwdriver tip before use to avoid damage.