2006-2011 Camry Aurion · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built Jun 2006 – May 2009

HINT:
  1. Use the same procedures for the RH side and the LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

  1. C132653
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    HINT:
    Do not disconnect the flexible hose from the disc brake caliper assembly.


3. REMOVE REAR DISC

  1. C132813E03
    Release the parking brake and put matchmarks on the rear disc and the axle hub.

  1. Remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.


4. REMOVE PARKING BRAKE SHOE RETURN TENSION NO. 1 SPRING

  1. C132651
    Using needle-nose pliers, remove the 2 parking brake shoe return tension No. 1 springs.


5. REMOVE PARKING BRAKE SHOE STRUT
  1. Remove the parking brake shoe strut and the parking brake shoe strut compression spring.


6. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY

  1. C133469
    Release the claw of the parking brake shoe hold down spring No. 1 cup.

  1. Remove the No. 1 parking brake shoe assembly as shown in the illustration.

  1. Remove the parking brake shoe hold down spring No. 1 cup, the parking brake shoe hold down spring, the parking brake shoe hold down spring No. 2 cup, and the parking brake shoe hold down spring No. 1 pin.


7. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET

  1. C133473E01
    Remove the parking brake shoe adjusting screw set.

  1. Remove the parking brake shoe return tension No. 2 spring.


8. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY

  1. C133471
    Release the claw of the parking brake shoe hold down spring No. 1 cup.

  1. Remove the No. 2 parking brake shoe assembly as shown in the illustration.

  1. Remove the parking brake shoe hold down spring No. 1 cup, the parking brake shoe hold down spring, the parking brake shoe hold down spring No. 2 cup, and the parking brake shoe hold down spring No. 2 pin.

  1. C108700
    Using needle-nose pliers, disconnect the No. 3 parking brake cable assembly from the parking brake shoe lever.

    NOTICE:
    Be careful not to damage the No. 3 parking brake cable assembly.


9. REMOVE PARKING BRAKE SHOE LEVER

  1. C132646
    Using a screwdriver, remove the C-washer, shim and the parking brake shoe lever.


10. REMOVE PARKING BRAKE SHOE GUIDE PLATE

  1. C141958
    Remove the parking brake shoe guide plate set bolt and the parking brake shoe guide plate.

← COMPONENTS (Jun 2006 – May 2009)INSPECTION (Jun 2006 – May 2009) →