Clutch Switch Circuit
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
DESCRIPTION
Clutch switch circuit inspection is necessary for M/T vehicles.When the clutch pedal is released, the ECM receives positive (+) battery voltage through the ECU IG NO. 2 fuse. While depressing the clutch pedal, the clutch switch sends a signal to terminal D of the ECM. The ECM cancels cruise control drive when terminal D receives the signal.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT ECM |
Disconnect the C24 connector from the ECM.

Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
C24-56 (D) - Body ground
Clutch pedal depressed
Below 1 V
Clutch pedal released
10 to 14 V
|
|
||||
| NG | |
| 2. INSPECT CLUTCH SWITCH ASSEMBLY |
Turn the ignition switch off.

Disconnect the A21 connector from the clutch switch.
Remove the clutch switch (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Switch pin free
10 kΩ or higher
Switch pin pushed in
Below 1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
C24-56 (D) - A21-2
Always
Below 1 Ω
C24-56 (D) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
