2006-2011 Camry Aurion · Service Manual CRUISE CONTROL SYSTEM

Clutch Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

Clutch switch circuit inspection is necessary for M/T vehicles.
When the clutch pedal is released, the ECM receives positive (+) battery voltage through the ECU IG NO. 2 fuse. While depressing the clutch pedal, the clutch switch sends a signal to terminal D of the ECM. The ECM cancels cruise control drive when terminal D receives the signal.

WIRING DIAGRAM

E113306E09

INSPECTION PROCEDURE


1. INSPECT ECM

  1. A136781E17
    Disconnect the C24 connector from the ECM.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    C24-56 (D) - Body ground
    Clutch pedal depressed
    Below 1 V
    Clutch pedal released
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. INSPECT CLUTCH SWITCH ASSEMBLY

  1. E133093E01
    Turn the ignition switch off.

  1. Disconnect the A21 connector from the clutch switch.

  1. Remove the clutch switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch pin free
    10 kΩ or higher
    Switch pin pushed in
    Below 1 Ω



NG
REPLACE CLUTCH SWITCH ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR

  1. E135408E03
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    C24-56 (D) - A21-2
    Always
    Below 1 Ω
    C24-56 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - CLUTCH SWITCH)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - CLUTCH SWITCH)


← Clutch Switch Circuit (Oct 2006 – May 2009)Cruise Control Switch Circuit (Oct 2006 – May 2009) →