2006-2011 Camry Aurion · Service Manual CRUISE CONTROL SYSTEM

P0500 Vehicle Speed Sensor Malfunction

Diagnostic trouble codes · Vehicles built Jun 2006 – Sep 2006

Also covers:

DESCRIPTION

The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system (Click here). The speed signal is converted for use by the cruise control inside the ECM. Both the SFI system and the cruise control system can set DTC P0500, however the detection conditions of the two systems are different.
DTC No.
DTC Detection Condition
Trouble Area
P0500
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 sec. or more while cruise control is in operation.
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. ECM
  4. Combination meter assembly
P0503
Momentary interruption and noise are detected when a rapid change of vehicle speed occurs while cruise control is in operation.
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. ECM
  4. Combination meter assembly

WIRING DIAGRAM

Refer to DTC P0500 (Click here).

INSPECTION PROCEDURE

Refer to DTC P0500 (Click here).

← DIAGNOSTIC TROUBLE CODE CHART (Jun 2006 – Sep 2006)P0571 Brake Switch "A" Circuit (Jun 2006 – Sep 2006) →