Navigation ECU Communication Stop Mode
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Navigation ECU Communication Stop Mode |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
- Turn the ignition switch off before inspecting CAN bus wires for a ground short.
- After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1minute and do not operate the ignition switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
- Turn the ignition switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
- HINT:
- Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
- Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
- Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
| 1. CHECK OPEN IN CAN BUS WIRE (NAVIGATION ECU BRANCH WIRE) |
Turn the ignition switch off.
Disconnect the navigation receiver assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
F12-2 (CANH) - F12-3 (CANL)
Ignition switch off
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
F36-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
F36-3 (ACC) - Body ground
Ignition switch ACC
11 to 14 V
F13-2 (IG) - Body ground
Ignition switch ON
11 to 14 V
- Result:
Result
Proceed to
OK (for 2GR-FE)
A
OK (Except 2GR-FE)
B
NG
C
|
|
||||
|
|
||||
| A | ||
| ||
