2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Navigation ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Jun 2009

DESCRIPTION

Detection Item
Symptom
Trouble Area
Navigation ECU Communication Stop Mode
  1. "AVN1" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Navigation ECU Communication Stop Mode" in the "DTC Combination Table"
  1. Display and navigation ECU branch line or connector
  2. Power source circuit of navigation ECU
  3. Navigation ECU (Navigation receiver assembly)

WIRING DIAGRAM

C208514E06

INSPECTION PROCEDURE

NOTICE:
  1. Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
  2. Turn the engine switch off before inspecting CAN bus wires for a ground short.
  3. After the engine switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  4. Before measuring the resistance, leave the vehicle as is for at least 1minute and do not operate the engine switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.


1. CHECK OPEN IN CAN BUS WIRE (NAVIGATION ECU BRANCH LINE)
  1. Turn the engine switch off.

  1. E168565E13
    Disconnect the navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F12-2 (CANH) - F12-3 (CANL)
    Engine switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (NAVIGATION ECU BRANCH WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)

  1. E168564E54
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F36-7 (GND) - Body ground
    Always
    Bellow 1 Ω

  1. E168562E42
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F36-3 (ACC) - Body ground
    Engine switch on (ACC)
    11 to 14 V
    F13-2 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V

    Result:
    Result
    Proceed to
    OK (for 2GR-FE)
    A
    OK (Except 2GR-FE)
    B
    NG
    C



B
NAVIGATION RECEIVER ASSEMBLY (NAVIGATION ECU) (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (NAVIGATION ECU) (Click here)


← Center Airbag Sensor Communication Stop Mode (from Oct 2006)CAN Bus Line (Oct 2006 – May 2009) →