INSTALLATION
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING |
 |
- Install the front shock absorber with coil spring to the front axle assembly and insert the 2 bolts from the rear of the vehicle.
- Slowly jack up the vehicle using a wooden block and install the front shock absorber with coil spring (upper side) to the vehicle.
- Install the 3 nuts to the upper side of the front shock absorber with coil spring.
-
Torque:
- 85 N*m{
867 kgf*cm
, 63 ft.*lbf
}
- Install the 2 nuts to the lower side of the front shock absorber with coil spring.
-
Torque:
- 210 N*m{
2,140 kgf*cm
, 155 ft.*lbf
}
- NOTICE:
- When installing the nuts, keep the bolts from rotating.
- Install the front flexible hose and front speed sensor wire harness with the bolt to the shock absorber with coil spring.
-
Torque:
- 19 N*m{
194 kgf*cm
, 14 ft.*lbf
}
- NOTICE:
- Do not twist the front speed sensor wire harness when installing it.
- Fully tighten the lock nut.
-
Torque:
- 70 N*m{
714 kgf*cm
, 52 ft.*lbf
}
| 2.
INSTALL FRONT STABILIZER LINK ASSEMBLY |
 |
- Install the front stabilizer link assembly with the nut to the front shock absorber with coil spring.
-
Torque:
- 74 N*m{
755 kgf*cm
, 55 ft.*lbf
}
- HINT:
- If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
| 3.
INSTALL FRONT WHEEL |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}
| 4.
CHECK ABS SPEED SENSOR SIGNAL |
 |
- HINT:
- ABS: Click here
- VSC: Click here
| 5.
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
 |
(Click here)