2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2006

HINT:
  1. Use the same procedures for the RH side and the LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT WHEEL

2. SEPARATE FRONT STABILIZER LINK ASSEMBLY

  1. C132410E01
    Support the front suspension lower No. 1 arm with a jack using a wooden block.

  1. C144427E03
    Remove the nut and separate the front stabilizer link assembly from the front shock absorber with coil spring.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.


3. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING

  1. C132412
    Loosen the lock nut of the front shock absorber with coil spring.

    NOTICE:
    1. Do not remove the lock nut.
    2. Only loosen the nut when disassembling the front shock absorber with coil spring.

  1. C132413
    Remove the bolt and disconnect the front flexible hose and front speed sensor wire harness from the front shock absorber with coil spring.

    NOTICE:
    Be sure to remove the front speed sensor from the front shock absorber with coil spring.

  1. C132414
    Remove the 2 nuts on the lower side of the front shock absorber with coil spring.

    NOTICE:
    1. When removing the nuts, keep the bolts from rotating.
    2. Keep the bolts inserted to secure the front axle assembly.

  1. C132415
    Remove the 3 nuts on the upper side of the front shock absorber with coil spring.

  1. C144664
    Remove the 2 bolts and front shock absorber with coil spring.

    NOTICE:
    Make sure that the front speed sensor is disconnected from the front shock absorber with coil spring.

← COMPONENTS (from Jun 2006)DISASSEMBLY (from Jun 2006) →