2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM
  1. Install the front lower arm bushing stopper.

  1. Install the front suspension lower No. 1 arm to the front frame assembly with the 3 bolts and the nut, but do not tighten them yet.

  1. C144659E01
    Tighten the 3 bolts.

    Torque:
    Bolt A:
    200 N*m{ 2,040 kgf*cm , 148 ft.*lbf }
    Bolt B:
    206 N*m{ 2,100 kgf*cm , 152 ft.*lbf }


2. INSTALL ENGINE MOUNTING INSULATOR

  1. C138032E01
    Install the engine mounting insulator with the 3 nuts and temporarily tighten the 3 nuts.


3. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for installation of the engine assembly (Click here).


4. FULLY TIGHTEN ENGINE MOUNTING INSULATOR

  1. C146045E01
    Fully tighten the 3 nuts.

    Torque:
    87 N*m{ 887 kgf*cm , 64 ft.*lbf }


5. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← REMOVAL (from Jun 2009)INSTALLATION (Oct 2006 – May 2009) →