2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL NO. 1 FRONT STABILIZER BAR BUSHING

  1. C145489E01
    Install the 2 No. 1 front stabilizer bar bushings to the outside of the bushing stopper on the front stabilizer bar.

    NOTICE:
    Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.


2. INSTALL NO. 1 FRONT STABILIZER BRACKET LH
  1. Install the No. 1 front stabilizer bracket LH.


3. INSTALL NO. 1 FRONT STABILIZER BRACKET RH
  1. Install the No. 1 front stabilizer bracket RH.


4. INSTALL FRONT STABILIZER BAR

  1. C143302E01
    Install the front stabilizer bar with the 2 bolts. (LH Side)

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }

  1. C143303E01
    Install the front stabilizer bar with the 2 bolts. (RH Side)

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }


5. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for installation of the engine assembly (Click here).


6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

  1. C144426E02
    Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.


7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedures as for the LH side.


8. CONNECT TIE ROD END SUB-ASSEMBLY
  1. Install the tie rod end sub-assembly to the steering knuckle with the nut.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.


9. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY

  1. C148635E01
    Align the matchmarks on the steering intermediate shaft and the power steering link assembly.

  1. C148636E01
    Install the bolt.

    Torque:
    35 N*m{ 360 kgf*cm , 26 ft.*lbf }


10. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

11. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSPECTION (from Jun 2006)INSTALLATION (Oct 2006 – May 2009) →