2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

REASSEMBLY

Removal / installation · Vehicles built from Jun 2006


1. INSTALL REAR SHOCK ABSORBER
  1. Install the No. 1 rear spring bumper to the piston rod.

  1. Install the lower rear coil spring insulator onto the rear shock absorber.

  1. C104393E01
    Using SST, compress the rear coil spring.
    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Do not use an impact wrench.

  1. C132470E01
    Install the rear coil spring to the rear shock absorber.

    NOTICE:
    The smaller diameter end must face upward.

    HINT:
    1. Fit the lower end of the rear coil spring into the gap of the lower seat.
    2. If the rear coil spring is compressed at an angle, using 2 SST will make the work easier.

  1. C132469E01
    Install the rear suspension support assembly.

    NOTICE:
    Align the notches of the piston rod and the rear suspension support assembly as shown in the illustration before installing the rear suspension support assembly.

  1. C132471E01
    Align the notches of the shock absorber with the notch of the rear suspension support assembly so that the notches face the outside of the vehicle.

  1. Install the rear shock absorber collar.

  1. Temporarily tighten a new lock nut to the rear shock absorber piston rod.

  1. C132472E01
    Release the spring while adjusting the rear suspension support assembly to the position shown in the illustration, and remove the SST from the rear coil spring.

    NOTICE:
    Do not use an impact wrench.

    HINT:
    When lining up the rear suspension support assembly's stud bolts at the middle point between the two sides of the bracket, the maximum permissible degree of error is +-5°.

← INSPECTION (from Jun 2006)INSTALLATION (Jun 2006 – Sep 2006) →