2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Jun 2006


1. INSTALL REAR STRUT ROD

  1. C132496
    Install the rear strut rod (rear side), bolt and nut, and temporarily tighten the bolt.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.

  1. C132459E01
    Support the rear axle carrier.

  1. C132475
    Connect the rear strut rod (front side) with the bolt and nut.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.


2. STABILIZE SUSPENSION

  1. C108450E01
    Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.


3. FULLY TIGHTEN REAR STRUT ROD

  1. C132476
    Fully tighten the bolt.

    Torque:
    113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }

  1. C132475
    Fully tighten the bolt.

    Torque:
    113 N*m{ 1,152 kgf*cm , 83 ft.*lbf }


4. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

  1. C132474
    Install the No. 3 parking brake cable assembly with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }


5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← REMOVAL (from Jun 2006)COMPONENTS (Jun 2006 – Sep 2006) →