2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL REAR STABILIZER BUSHING

  1. C145831E01
    Install the 2 rear stabilizer bushings to the outside of the stopper ring on the stabilizer bar as shown in the illustration.


2. INSTALL NO. 2 REAR STABILIZER BAR BRACKET
  1. Install the No. 2 rear stabilizer bar bracket.


3. INSTALL NO. 1 REAR STABILIZER BAR BRACKET
  1. Install the No. 1 rear stabilizer bar bracket.


4. INSTALL REAR STABILIZER BAR

  1. C145565
    Install the rear stabilizer bar with the 2 bolts. (LH Side)

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }

  1. C145566
    Install the rear stabilizer bar with the 2 bolts. (RH Side)

    Torque:
    31 N*m{ 316 kgf*cm , 23 ft.*lbf }


5. INSTALL REAR STABILIZER LINK ASSEMBLY LH

  1. C144428E01
    Connect the rear stabilizer link assembly LH with the nut.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.


6. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedures as for the LH side.


7. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for 2AZ-FE)
  1. Install a new gasket onto the front exhaust pipe.

  1. Install the center exhaust pipe assembly with the 2 bolts and 2 nuts.

    A146049

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }


8. INSTALL CENTER EXHAUST PIPE ASSEMBLY (for 2GR-FE)
  1. Install a new gasket to the center exhaust pipe assembly.

  1. Install the center exhaust pipe to the exhaust front pipe with the 2 nuts and 2 bolts.

    A146045

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }


9. INSTALL TAIL EXHAUST PIPE ASSEMBLY (for 2GR-FE)
  1. Install 2 new gaskets to the exhaust tail pipes.

  1. Install the 2 exhaust tail pipes with the 4 nuts.

    A146044

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


10. INSTALL REAR WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


11. INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.
← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →