DATA LIST / ACTIVE TEST
System information · Vehicles built from Jun 2006
| DATA LIST |
- HINT:
- Using the intelligent tester Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to shorten labor time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the tester.
Main Body (Main body ECU): Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key Unlock Warning Switch
Unlock warning switch / ON or OFF
ON: Ignition key is inserted
OFF: Ignition key is not inserted
-
Wireless Control
Wireless door lock control function / ON or OFF
ON: Operating
OFF: Not operating
-
Hazard Answer Back
Hazard answer-back of wireless / ON or OFF
ON: Operating
OFF: Not operating
-
Open Door Warning
Open door warning / ON or OFF
ON: Operating
OFF: Not operating
-
Auto Lock Time
Automatic lock time / 60 s or 30 s
60 s: 60 seconds
30 s: 30 seconds
-
Unlock 2 Operation
2 times operation of wireless unlock / ON or OFF
ON: All doors unlock when UNLOCK switch pressed twice
OFF: All doors unlock when UNLOCK switch pressed once
-
Panic Alarm Function
Panic function / ON or OFF
ON: Operating
OFF: Not operating
-
Wireless Buzzer Resp
Wireless door lock buzzer response / ON or OFF
ON: Operating
OFF: Not operating
-
Trunk Lid Operation
Luggage compartment door open function type / 1tim ON/2tim ON/Long1/Long2/Prohibit
1tim ON: Luggage compartment door opens when LUGGAGE OPEN switch is pressed once
2tim ON: Luggage compartment door opens when LUGGAGE OPEN switch is pressed twice
Long1: Luggage compartment door opens when LUGGAGE OPEN switch is pressed and held down for 0.6 seconds
Long2: Luggage compartment door opens when LUGGAGE OPEN switch is pressed and held down for 0.8 seconds
Prohibit: Not operating
-
| ACTIVE TEST |
- HINT:
- Performing the intelligent tester Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to shorten the labor time. The Data List can be displayed during the Active Test.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Enter the following menus: Body / Main Body / Active Test.
Perform the Active Test according to the display on the tester.
Main Body (Main body ECU): Tester Display
Test Part
Control Range
Diagnostic Note
Wireless Buzzer
Wireless door lock buzzer
ON/OFF
-
Hazard
Turns the turn signal flasher relay
ON/OFF
Observe headlight and rear combination light for correct operation
Vehicle Horn
Turns the vehicle horns
ON/OFF
-
Illuminated Entry System
Interior light and ignition key cylinder light (Interior light switch is in DOOR position and all doors are closed)
ON/OFF
-
Trunk and Back-Door Open
Turns the luggage compartment door opener motor
ON/OFF
Observe luggage compartment door