2006-2011 Camry Aurion · Service Manual BODY

DATA LIST / ACTIVE TEST

System information · Vehicles built from Oct 2006


USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  2. Monitor the ECU data by following the prompts on the tester screen.

    HINT:
    The intelligent tester has a "Snapshot" function which records the monitored data. Refer to the intelligent tester operator's manual for further details.


DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Read the Data List according to the display on the tester.

    Mirror-L/Mirror-R:
    Tester Display
    Measurement Item/Range
    Normal Condition
    RH Mir Pos Sen V
    Vertical mirror position/MIN: 0, MAX: 5 V
    Within range from 0 to 5 V
    RH Mir Pos Sen V
    Vertical mirror position/MIN: 0, MAX: 5 V
    Within range from 0 to 5 V
    LH Mir Pos Sen H
    Horizontal mirror position/MIN: 0, MAX: 5 V
    Within range from 0 to 5 V
    LH Mir Pos Sen H
    Horizontal mirror position/MIN: 0, MAX: 5 V
    Within range from 0 to 5 V
    Mirror Mem 1
    Mirror position memorized in memory switch M1/ON (1) or OFF (0)
    1: Memorized
    0: Not memorized
    Mirror Mem 2
    Mirror position memorized in memory switch M2/ON (1) or OFF (0)
    1: Memorized
    0: Not memorized
    D Set Memory
    Driving position memorized in seat memory switch MEMORY/ON (1) or OFF (0)
    1: Memorized
    0: Not memorized
    D Mem 1 SW
    Driving position memorized in seat memory switch M1/ON (1) or OFF (0)
    1: Memorized
    0: Not memorized
    D Mem 2 SW
    Driving position memorized in seat memory switch M2/ON (1) or OFF (0)
    1: Memorized
    0: Not memorized


ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Perform the Active Test according to the display on the tester.

    Mirror-L/Mirror-R:
    Tester Display
    Test Part
    Control Range
    RH Mirror Up/Down
    Mirror vertical operation: UP/DOWN
    -
    RH Mirror Right/Left
    Mirror horizontal operation: RIGHT/LEFT
    -
    LH Mirror Up/Down
    Mirror vertical operation: UP/DOWN
    -
    LH Mirror Right/Left
    Mirror horizontal operation: RIGHT/LEFT
    -

← DIAGNOSIS SYSTEM (from Oct 2006)Power Mirror cannot be Adjusted with Power Mirror Switch (from Oct 2006) →