2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Rear Door Lock Motor LH Circuit

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

The rear left door lock motor is built into the rear left door lock assembly.
The main body ECU controls the rear left door lock motor to lock/unlock the rear left side door. This ECU applies current from terminal ACT+ to terminal ACT- to operate the motor to lock the door. It reverses the direction of the current flow to operate the motor to unlock the door.

WIRING DIAGRAM

B109771E17

INSPECTION PROCEDURE


1. INSPECT REAR DOOR LOCK ASSEMBLY

  1. E123890E04
    Remove the rear door lock assembly LH.

  1. Apply battery voltage and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlock



NG
REPLACE REAR DOOR LOCK ASSEMBLY
OK


2. CHECK WIRE HARNESS (REAR DOOR LOCK - MAIN BODY ECU (INSTRUMENT PANEL J/B))

  1. Disconnect the rear door lock assembly LH connector.B112611E01

  1. Disconnect the ECU (instrument panel J/B) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    K5-4 (L) - IP-11
    Always
    Below 1 Ω
    K5-1 (UL) - IP-6
    Always
    Below 1 Ω
    IP-11 - Body ground
    Always
    10 kΩ or higher
    IP-6 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Front Passenger Side Door Lock Motor Circuit (from Jun 2006)Rear Door Lock Motor RH Circuit (from Jun 2006) →