2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Rear Door Lock Motor RH Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The rear right door lock motor is built into the rear right door lock assembly.
The main body ECU (instrument panel J/B) controls the rear right door lock motor to lock/unlock the rear right door. This main body ECU (instrument panel J/B) applies current from terminal ACT+ to terminal ACT- to operate the motor to lock the door. It reverses the direction of the current flow to operate the motor to unlock the door.

WIRING DIAGRAM

B109771E30

INSPECTION PROCEDURE


1. INSPECT REAR DOOR LOCK ASSEMBLY

  1. E123891E03
    Remove the rear door lock assembly RH (Click here).

  1. Apply battery voltage and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlock



NG
REPLACE REAR DOOR LOCK ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK - MAIN BODY ECU)

  1. Disconnect the instrument panel J/B connector.B138122E08

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    J5-4 (L) - IF-5
    Always
    Below 1 Ω
    J5-1 (UL) - IF-18
    Always
    Below 1 Ω
    IF-5 - Body ground
    Always
    10 kΩ or higher
    IF-18 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Rear Door Lock Motor LH Circuit (from Jun 2009)Rear Door Lock Motor RH Circuit (from Jun 2009) →