Stereo Component Amplifier Power Source Circuit
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
This circuit provides power to the stereo component amplifier.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT STEREO COMPONENT AMPLIFIER |
Disconnect the stereo component amplifier connector.

Measure the resistance according to the value(s) in the table below .
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F46-10 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F46-5 (+B) - F46-10 (GND)
Always
11 to 14 V
F46-12 (ACC) - F46-10 (GND)
Ignition switch on (ACC)
11 to 14 V
| *1 |
Front view of wire harness connector (to Stereo Component Amplifier) |
|
|
||||
| OK | |
| 2. INSPECT STEREO COMPONENT AMPLIFIER |
Disconnect the stereo component amplifier connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F46-9 (AMP+) - F46-10 (GND)
Ignition switch on (IG)
11 to 14 V
| *1 |
Front view of wire harness connector (to Stereo Component Amplifier) |
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR |
Disconnect the stereo component amplifier and radio receiver connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F46-9 (AMP+) - F6-9 (AMP)
Always
Below 1 Ω
F46-9 (AMP+) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
