2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

CUSTOMIZE PARAMETERS

Troubleshooting · Vehicles built from Oct 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006


COMBINATION METER ASSEMBLY
*1: for G.C.C. Countries
*2: for Australia

NOTICE:
  1. Be sure to record the current value before customizing.

HINT:
The following items can be customized using the intelligent tester.

Combination Meter: 
Tester Display
Default
Contents
Setting
Key Remind Volume
Large
Function to change the volume of the key remind warning buzzer
Large, Medium, Small
Key Remind Sound
Normal
Function to change the cycle of the key remind warning buzzer
Fast, Normal, Slow
Seat-belt Warning Buzzer
D/P ON (*1)
Function to change the setting of the seat belt buzzer.
D/P ON, D ON, P ON, D/P OFF (*1)
D ON (*2)
D ON, D OFF (*2)

HINT:
This setting is only valid for the buzzer which sounds at the 5 km/h (3 mph) or more.


CLOCK ASSEMBLY (For Australia)

  1. Speed Warning Preset Mode:
    E134518E02

    1. Ignition switch on (IG).

    2. Press and hold the MODE button for 1 second or more.

    3. Select the vehicle speed by pressing the arrow down/arrow up button.

    4. Press the MODE button to set the new value.

      HINT:
      Set the vehicle speed over 130 km/h to disable above warning mode. (Speed limit warning display shows "--".)

  2. Speed Warning Manual Mode:

    1. Ignition switch on (IG).

    2. Press the MODE button until manual mode appears.

    3. The customized setting is displayed.

    4. Select the vehicle speed by pressing the arrow down/arrow up button.

    5. Press the MODE button to set the new value.

      HINT:
      Set the vehicle speed over 130 km/h to disable above warning mode. (Speed limit warning display shows "--".)

  3. Clock Mode (Speed Limit Warning Disabled):

    1. Ignition switch on (IG).

    2. Press and hold the MODE button until clock mode appears. (Speed limit warning display is blank.)

    3. Press the MODE button for 1 second or more.

    4. Hours digit starts blinking.

    5. Press the arrow down/arrow up button to adjust the hour.

    6. Press the MODE button.

    7. Minutes digit starts blinking.

    8. Press the arrow down/arrow up button to adjust the minute.

    9. Press the MODE button.

    10. The minutes digit stops blinking, the colon start flashing, and exit the clock mode.

      HINT:
      1. Press MODE button once in manual mode or twice in preset mode, speed warning display will become blank and disable the speed warning function.
      2. Press the MODE button again to enable the speed limit warning again.

← CUSTOMIZE PARAMETERS (Jun 2006 – Sep 2006)PROBLEM SYMPTOMS TABLE (Jun 2006 – Sep 2006) →