2006-2011 Camry Aurion · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


INSPECT THROTTLE BODY ASSEMBLY
  1. Check for the throttle control motor operating sounds.

    1. Turn the ignition switch to the ON position.

    2. When pressing the accelerator pedal position sensor lever, listen to the running motor. Make sure that no friction noise comes from the motor.
      If friction noise exists, replace the throttle body assembly.

  1. Inspect the throttle position sensor.

    1. B139188E09
      Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Check that the MIL turns off.

    4. Under CURRENT DATA, the throttle valve opening percentage (Throttle Position) should be within the standard range below.

      Standard throttle valve opening percentage:
      60% or more

      If the percentage is less than 60%, replace the throttle body assembly.

      NOTICE:
      When checking the throttle valve opening percentage, the transmission should be in neutral.

← COMPONENTS (from Jun 2006)ON-VEHICLE INSPECTION (from Jun 2009) →