REMOVAL
Removal / installation · Vehicles built from Jun 2006
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 3.
REMOVE FRONT FENDER APRON RH |
|
| 4.
REMOVE V-RIBBED BELT
|
 |
- Using SST and a 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the V-ribbed belt.
- SST
- 09216-42010
- NOTICE:
- Be sure to connect SST and the tools so that they are in line during use.
- When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
- After the tensioner is fully retracted, do not apply more force than necessary.
| 5.
REMOVE GENERATOR ASSEMBLY
|
 |
- Disconnect the generator connector.
Remove the nut and disconnect the wire harness from terminal B.
Remove the bolt and wire harness clamp bracket.
Remove the wire harness clamp.
- Remove the 2 bolts and generator assembly.
| 6.
REMOVE CRANKSHAFT POSITION SENSOR |
 |
- Disconnect the crankshaft position sensor connector.
Remove the connector clamp and wire harness clamp.
Remove the wire harness clamp bracket from the wire harness.
Remove the bolt, and then remove the crankshaft position sensor.