2006-2011 Camry Aurion · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL AIR FUEL RATIO SENSOR
  1. Temporarily tighten the air fuel ratio sensor.

    NOTICE:
    Do not damage the air fuel ratio sensor.

  1. A146204E01
    Using SST, fully tighten the air fuel ratio sensor.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).

  1. A135681E01
    Connect the air fuel ratio sensor connector and clamp.


2. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

  1. A135682
    Install the exhaust manifold heat insulator with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

← INSPECTION (from Jun 2006)INSTALLATION (Oct 2006 – May 2009) →