2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

OPERATION CHECK

Troubleshooting · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


CHECK ELECTRICAL DOOR LOCK OPERATION

NOTICE:
The initial condition that the customizing function using the intelligent tester is not chosen is shown.

  1. Check the basic function.

    1. Check that all doors lock when the door control switch (for manual operation) is turned to LOCK and all doors unlock when turned to UNLOCK.

    2. Check that all doors lock when the driver door lock key cylinder is turned to LOCK using the mechanical key.

  2. Check the electrical key lock-in prevention function (with Smart Entry and Start System).

    NOTICE:
    In order to prevent the electrical key from being actually locked-in, the following inspection should be performed with the driver door window open.


    1. Turn the engine switch on (IG) or (ACC).

    2. With the driver door open, check that all doors unlock immediately after the driver door lock knob is locked.

    3. With the driver door open, check that all doors unlock immediately after the lock side of the door control switch (for manual operation) is pressed.

    4. With the driver door open, lock the driver door lock knob and hold it for 2 seconds or more, then close the driver door and check that all doors unlock.

  3. Check the key lock-in prevention function (without Smart Entry and Start System).

    NOTICE:
    In order to prevent the key from being actually locked-in, the inspection should be performed with the driver door window open.


    1. Have the key inserted into the ignition key cylinder.

    2. With the driver door open, check that all doors unlock immediately after the driver door lock knob is turned to LOCK.

    3. With the driver door open, check that all doors unlock immediately after the lock side of the door control switch (for manual operation) is pressed.

    4. With the driver door open, turn the driver door lock knob to LOCK, and then close the driver door. Then check that all doors unlock.

  4. Check the security function.

    1. *1: with Smart Entry and Start System
    2. *2: without Smart Entry and Start System

    1. Close all doors with the driver door window open so that the door control switch can be operated from outside the vehicle.

    2. Pull out the electrical key (*1) or mechanical key (transmitter) (*2), open the driver door and then close and lock the door using the electrical key (*1) or mechanical key (transmitter) (*2). Under this condition, check that all doors do not unlock when the unlock side of the door control switch (for manual operation) is pressed from outside the vehicle.

    3. Pull out the electrical key (*1) or mechanical key (transmitter) (*2), and close and lock the driver door by mechanical key operation. Under this condition, check that all doors do not unlock when the unlock side of the door control switch (for manual operation) is pressed from outside the vehicle.

    4. Pull out the electrical key (*1) or mechanical key (transmitter) (*2), close the driver door, and lock the door by wireless door lock operation. Under this condition, check that all doors do not unlock when the unlock side of the door control switch (for manual operation) is pressed from outside the vehicle.

      HINT:
      Check that the security function is canceled under the following conditions:
      1. The ignition switch is turned on (IG).
      2. The driver door is unlocked using the electrical key (*1) or mechanical key (transmitter) (*2).
      3. The unlock side of the door control switch (for manual operation) is pressed after the door control knob is turned to UNLOCK manually.

  5. Check the illumination function.

    1. Set the room light switch to the DOOR position.

    2. With all doors locked, check that all doors unlock when the driver door lock key cylinder is turned to UNLOCK using the key. At the same time, the room light comes on.

    3. Check that the room light goes off in approximately 15 seconds if the doors have not been opened.

← OPERATION CHECK (Jun 2006 – May 2009)CUSTOMIZE PARAMETERS (from Jun 2006) →