2006-2011 Camry Aurion · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jun 2006


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE RADIATOR RESERVE TANK ASSEMBLY

  1. C143552
    Separate the radiator reserve tank hose.

  1. C144510E01
    Remove the radiator reserve tank assembly.


3. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately clean it off completely.


4. REMOVE BRAKE ACTUATOR WITH BRAKE ACTUATOR BRACKET ASSEMBLY

  1. C132775E01
    Release the lock lever and disconnect the brake actuator connector.

  1. C132776E01
    Using SST, disconnect the 6 brake lines from the brake actuator with brake actuator bracket assembly.
    SST
    09023-00101  

  1. C132777E01
    Use tags or make a memo to identify the places to reconnect.

    HINT:
    1. *1: To Front Wheel Cylinder RH
    2. *2: To Front Wheel Cylinder LH
    3. *3: To Rear Wheel Cylinder RH
    4. *4: To Rear Wheel Cylinder LH
    5. *5: From 2nd Master Cylinder
    6. *6: From 1st Master Cylinder

    NOTICE:
    Plug the brake line holes immediately after disconnection.

  1. C132778
    Remove the 3 bolts and brake actuator with brake actuator bracket assembly from the body.

    NOTICE:
    Do not damage the brake lines or wire harness.

← ON-VEHICLE INSPECTION (from Jun 2006)DISASSEMBLY (from Jun 2006) →